Rust Remover

RUST REMOVER is a concentrated aqueous liquid solution consisting of a blend of synergetic antioxidants and passivators. It is used to remove rust from any steel surface area and rust stains from brass, copper, stainless steel, wood, ceramic and aluminum surfaces, painted or not. Additionally, it contributes to the rust proofing of metals before any painting or coating application.

Characteristics, Advantages & Applications

Readily removes rust and rust stains from metal and non-metal surfaces.
Protects and keeps surfaces free from corrosion.
Removes and prevents flash and light rust due to passivation.
Acts as a rust proofing agent before the application of paints or coatings.
Non-flammable, does not affect rubber or plastic compounds.
May be used with a specific range of other cleaning products.
Cost effective, easy to apply and use.

During 1996, chemical tankers were only permitted to use tank cleaning agents, which had been approved and evaluated by the International Maritime Organisation (IMO). RUST REMOVER was evaluated through IMO’s Working Group on the Evaluation of Safety and Pollution Hazards of Chemicals (ESPH Working Group) and found to meet the requirements of paragraph 1.8.2 of the P&A Standards.

Physical Properties

RUST REMOVER is a non-flammable mixture of special acids, passivators and emulsifiers.

Order No	Size (in litres)	Container
Appearance / Color	Clear, colorless liquid
Odor	Odorless
Specific gravity	1.23-1.25/15°C
pH	1
Solubility in water	Complete
833027	30	Plastic jerrican

Application and Use

A. Dosing Procedure

The quantity of RUST REMOVER to be used cannot be directly specified, since it depends on the cleaning results desired and the situation at hand. The user is the one responsible to regulate the quantity needed. However, when the cleaning application is determined, RUST REMOVER must be used diluted with fresh water with a percentage concentration ranging between 10-50% depending on the desired strength of the solution.

Note that a 10% solution is sufficiently strong can be used for most general/everyday situations involving rust.

The 50% solution is recommended when we have very difficult cases, involving areas that are very heavily encrusted with rust.

B. Cleaning Procedure

Before application, when the affected area has been determined, ensure the absence of oil, grease, dirt or other foreign matter. Then shake the RUST REMOVER well and prepare the desired concentration solution. The solution may now be applied either by brushing and/or injection. Smaller parts may be immersed directly into the prepared solution. In all of the above situations, you must allow RUST REMOVER to act for 20-40 minutes and then rinse thoroughly with high or regular pressure fresh water.

Note that in cases for where RUST REMOVER has been specifically used to rust proof an area, before it is to be painted or coated, there is no need to rinse with water.

Safety and Handling

SAFETY	IMMEDIATE ACTIONS
HANDLING	Handle with care. Store in a dry, cool and well ventilated environment.
Eye Contact	Avoid Eye contact. Otherwise, flush with plenty of water for a few minutes. Seek medical attention.
Skin Contact	Avoid Skin contact. Otherwise, wash contaminated area thoroughly with water. Seek medical attention.
Inhalation	Avoid inhalation of vapors. Otherwise, seek fresh air source at once. Seek medical attention.
If Swallowed	Avoid ingestion. Otherwise, consume a considerable quantity of water. Do not induce vomiting. Seek medical attention.
GENERAL INSTRUCTIONS	Avoid spillage, splashing and mishandling. Precautionary measures for body protection are strongly recommended before use.

Read the Material Safety Data Sheet before using this product.

For detailed information on safety and health, please refer to Material Safety Data Sheet and/or Product Label.